![]() ![]() ![]() Subsequently when you use the Airbrush in Multiply mode any pixels that changed in colour, as above, will give the impression of a slight halo in the same colour as used by the Airbrush. Some other actions that might also lead to a similar result are Cut & Paste, after using the Selection tool and softening paint edges with the Knife tool. One of the quirks of AR is that if you “tidy up” as it were the edge of a painted area with say the Eraser, for example, while Transparency Lock is active, rather than remove pixel colour AR changes those areas to the same colour as the Canvas Colour, which more often than not is very light. However, I wonder if you have performed any other actions on the painted area while Transparency Lock was active for that layer, but before using the Airbrush? In general use I am unable to produce the problem you are seeing. Is it noticeable when viewing the whole painting at its intended size? It looks from your screenshot that you are zoomed all the way in to the painting? And along the edge of the dress there seem to be semi transparent pixels or at least pixels containing white. Hello caitlinb and welcome to the ArtRage forums Is this something im doing wrong in artrage 6 perhaps ? Maybe it's me using this feature wrong or does anyone else have this happen sometimes? I've added a screenshot where an outlines showed up at the edge of the red part where I aitbrushed using a multiply effect (trying to add gentle shadows etc). ![]() Has anyone else gotten this? I used this all the time on ArtRage 5, and didnt have any issues then upgraded to ArtRage 6.1.2 and only sometimes this happens, but when it does happen I have to manually go around the outside of the whole area to hide the outline.Į.g A solid red circle on the layer > Lock Transparency > Airbrush any colour multiply over half the circle > The airbrushed half will have a blue outline ArtRage doesnt have layer clipping/masks so I duplicate a layer and use Lock Transparency to paint or shade but I've noticed thatin ArtRage 6 when I use Lock Transparency on a layer and paint on the locked layer I often get a blue outline showing at the edge of the locked section and I am not sure why. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |